12 0 tons of community natural gas boiler water tank

Furnaces and Boilers | Department of Energy

Gas-Fired Furnaces and Boilers (includes units fired with natural gas and propane) Oil-Fired Furnaces and Boilers . Other retrofitting options that can improve a system's energy efficiency include installing programmable thermostats upgrading ductwork in forced-air systems and adding zone control for hot-water systems an option discussed in ...

Get A Quote

Incorporate Minimum Efficiency Requirements for Heating ...

The Federal Energy Management Program (FEMP) organized information about FEMP-designated and ENERGY STAR-qualified heating ventilating and air conditioning (HVAC) and water heating products into tables that mirror American Society of Heating Refrigerating and Air-Conditioning Engineers (ASHRAE) 90.1-2016 minimum efficiency requirement tables.

Get A Quote

The Feedtank and Feedwater Conditioning | Spirax Sarco

British Standards BS 2486 recommends pH 10.5 - 12.0 for shell boilers @ 10 bar pH 9 could be used in higher pressure boilers only. To condition any suspended matter. This will be a flocculant or coagulant which will cause the suspended matter to agglomerate and sink to the bottom of the boiler from where it can be blown down.

Get A Quote

Resources | FIA Inc.

cu-xe15wkua + cs-xe15wkua - 1.225 ton. hspf = 12.0 (tier1) $500: $250: cu-xe18wkua + cs-xe18wkua - 1.433 ton. hspf = 12.0 (tier 1) $500: $250: cu-xe24wkua + cs-xe24wkua - 2 ton

Get A Quote

Department of Labor and Workforce Development | Boilers ...

Each automatically fired hot water boiler falling within the terms of N.J.S.A. 34:7-14(a) shall have an automatic low-water fuel cutoff which has been designed for hot water boiler service when such boiler exceeds a heat input of 400000 BTU per hour except that such low water cut off shall not be required for hot water supply boilers.

Get A Quote

Greenhouse Gases Equivalencies Calculator - Calculations ...

Therms and Mcf of natural gas. Carbon dioxide emissions per therm are determined by converting million British thermal units (mmbtu) to therms then multiplying the carbon coefficient times the fraction oxidized times the ratio of the molecular weight of carbon dioxide to carbon (44/12). 0.1 mmbtu equals one therm (EIA 2018).

Get A Quote